Tally Genicom 6600 - Manual (Page 44)

44
Chapter 2 Draft Fonts
Draft Fonts
The draft fonts, when issued inside a pass, select the font used for the
duration of that pass only. When used outside a pass, they select the font
used in all non-graphics printing.
Command ^@Cnn
Arguments
^@C Draft Font Command.
nn One of the draft font numbers listed below:
05 = double high (0.2 inch), 7.5 CPI.
10 = 10 CPI
12 = 12 CPI
13 = 13.3 CPI
15 = 15 CPI
17 = 17.1 CPI
Font/Quality Speed
Code V is capable of printing most of the Code V fonts at three different
speeds and qualities. The slowest print speed produces the highest quality
fonts, while the fastest print speed produces the lowest quality fonts. A Font
Quality/Speed Command may be sent either inside or outside of a pass and
remains in effect until another Font Quality/Speed Command is issued or
Graphics Mode is exited.
These commands only affect the Code V Draft Font at 12, 13.3, 15, and 17.1
CPI and the Code V NLQ Font at 10, 12, 13.3, and 17.1 CPI.
The three Code V Font Quality/Speed commands are: High-Quality Font, Full-
Space Font, and Half-Space Font.
High Quality Font Mode
Selects slow-speed, high quality fonts. The DPI of the font selected by a Code
V Font Command depends upon the selected font and may cause the paper
to back up and the shuttle to change speed. Fonts printed in this mode are
positioned on character cell boundaries.
Command ^~FQ
Full Space Font Mode
Selects 120 DPI, medium speed, medium quality fonts. The paper will not
back up to print any Code V font (excluding OCR) when ^~FF is selected.
This is the default.
Command ^~FF