Tally Genicom 6600 - Manual (Page 231)

Barcode Header
231
The default parameter values are the following:
• Unsecured mode (see section "Secured/Unsecured mode")
• HRI OFF, Normal Print, Double Pass (F = SP)
• Barcode Type 2/5 matrix (a = "A")
• Barcode height 1/6 inch (n = "1")
• Narrow bar (x = "0")
• Narrow space (y = "0")
• Ratio of wide to narrow 2 to 1 (z = "0")
When only parts of the header are to be changed, copy the header up to the
parameter which must be changed, and then close the header with the end-
of-header character. If a header error was detected the total previous features
are still active.
The "Barcode brackets" (hex.14, dec.20), initiate and terminate the printing of
the barcodes.
If the printer is switched OFFLINE, all defined barcodes are printed out
completely.
NOTE: The barcode remains resident in the background and can be
activated again by the barcode bracket. Text justification and
centering are both permitted. With activated barcodes these functions
are not carried out, since they lead to conflicts with the barcodes.
Transparent Barcode/LCP Commands
Following control codes in Barcode strings can be substituted by the
appropriate MTPL sequences (see “Special Features” on page 227).
These sequences may only be used with activated barcodes.
Table 44. MTPL Sequences Barcode Strings Substitution
Control Code ANSI Sequence (CSI = Hex 9B or ESC [ )
SUB CSI 26 Space s
EM CSI 25 Space s
DC4 CSI 20 Space s
DLE CSI 16 Space s
SI CSI 15 Space s
MTPL sequences without matching parameters will be ignored.