Tally Genicom 6600 - Manual (Page 294)

294
Appendix H Graphic Category (Menu Level 1)
PY Then Parameter (Menu Level 3)
This command defines printer response to characters following the ^PY
Command on the same line.
PY Then Selections (Menu Level 3)
None (Default)
All
Term
NOTE: How your printer responds to data and control codes that follow a ^PY
Command or a ^PN Command on the same line is shown in the
Code V Application section of the Graphics Application Manual in
Appendix I.
PN Then Parameter (Menu Level 2)
This command defines printer response to characters following the ^PN
Command on the same line.
NOTE: How your printer responds to data and control codes that follow a ^PY
Command or a ^PN Command on the same line is shown in the
Code V Application section of the Graphics Application Manual in
Appendix I.
PN Then Selections (Menu Level 3)
None (Default)
All
DarkBar Parameter (Menu Level 2)
This parameter allows you to increase the darkness of the barcodes by
changing horizontal dot density from 60 DPI to 120 DPI.
DarkBar Selections (Menu Level 3)
OFF (Default)
ON
Version Parameter (Menu Level 2)
This parameter controls the version of Code V the printer emulates.
Version Selections (Menu Level 3)
2 (Version 2) (Default selection)
1 (Version 1)