Tally Genicom 6600 - Manual (Page 170)

170
Chapter 9 PGL Commands
Page Number Command (Create)
This command allows you to place an automatically incremented page
number on each page in a specific location. The format for this command is:
The printer automatically increments the page numbers starting from the page
number specified in the EXECUTE command. If a page number is not
specified in EXECUTE command, no page number will print.
Table 14. Page Number Command
Field Function Option/Modifier Selections
PAGE; Command Specifier Enter PAGE
SR and SC parameters define the starting location of the page number. Whether in columns or
dots depends on the SCALE Command. You may also use the XX.YY format for plotting
duplication print locations explained earlier in the Standards Section.
SR; Plots the starting row of the page
number. Enter a value ranging from 1 to one less
than the maximum form length.
SC Plots the starting column of the
page number. Enter a value ranging from 1 to one less
than the maximum form width.