Tally Genicom 6600 - Manual (Page 181)

Change LPI Command (Normal and Execute)
181
Change LPI Command (Normal and Execute)
This command selects an LPI setting for printer output. This command affects
all printing in PGL mode except Overlay data. It will not reset the value
selected in the printer menu system. when you are not using the PGL option,
printer output is configured according to the settings in the pritner multi-level
menus.
Table 20. Change LPI Command
Field Function Option/Modifier Selections
LPI; Command Specifier. Change LPI
Command. Enter the current Special Function Control
Character followed by LPI, then end the
entry with the parameter delimiter.
n Designates the new LPI setting. Enter desired selection from the following
range: 6, 8, 9, and 10.