Hazard avoidance – Garmin G1000 King Air C90GT User Manual
Page 350
Garmin G1000 Pilot’s Guide for the Hawker Beechcraft C90A/GT
190-00663-01 Rev. A
336
HAZARD AVOIDANCE
SY
STEM
O
VER
VIEW
FLIGHT
INSTRUMENTS
EIS
AUDIO P
ANEL
& CNS
FLIGHT
MANA
GEMENT
HAZARD
AV
OID
ANCE
AFCS
ADDITIONAL FEA
TURES
APPENDICES
INDEX
3)
Turn the small FMS Knob to place the Bearing Line in the desired position. The location of the Bearing Line
becomes the center point of the Sector Scan.
4)
Turn the large FMS Knob to place the cursor in the SECTOR SCAN field.
5)
Turn the small FMS Knob to select FULL, 60˚, 40˚, or 20˚ scan.
6)
If desired, readjust the Bearing Line as discussed previously to change the center of the Sector Scan.
7)
Select the BRG Softkey again to remove the Bearing Line and cursor. The bearing reference is reset to 0º.
Figure 6-60 40˚ Sector Scan
a
ntenna
s
taBilization
1)
To activate or deactivate the antenna stabilization, select the MODE Softkey.
2)
Select the STAB ON Softkey to activate antenna stabilization or select the STAB OFF Softkey to deactivate. The
current stabilization condition is shown in the upper right of the weather radar display.