Garmin G1000 King Air C90GT - Manual (Page 75)

190-00663-01 Rev. A Garmin G1000 Pilot’s Guide for the Hawker Beechcraft C90A/GT 61
FLIGHT INSTRUMENTS
SY
STEM
O
VER
VIEW
FLIGHT
INSTRUMENTS
EIS
AUDIO P
ANEL
& CNS
FLIGHT
MANA
GEMENT
HAZARD
AV
OID
ANCE
AFCS
ADDITIONAL
FEA
TURES
APPENDICES
INDEX
If the barometric altimeter settings differ between PFDs by more than 0.02 in Hg, the readouts turn yellow.
The settings can be synchronized from the PFD Setup Menu. Once the settings are synchronized (BARO
SYNC turned on), they remain synchronized until the setting is turned off.
Synchronizing the altimeter barometric pressure settings:
1) Use the FMS Knob to select the AUX - System Setup Page on the MFD.
2) Press the FMS Knob to activate the cursor.
3) Turn the large FMS Knob to highlight the ‘Baro Sync’ in the Synchronization box.
4) Turn the small FMS Knob clockwise to ON or counterclockwise to OFF.
Figure 2-14 System Setup Page, Barometric Pressure Synchronization
Barometric Settings
not Synchronized on PFD
VERTICAL SPEED INDICATOR (VSI)
The Vertical Speed Indicator (VSI) displays the aircraft vertical speed using a non-moving tape labeled at 2000
and 4000 fpm with minor tick marks every 1000 fpm. The current vertical speed is displayed in the pointer
along the tape. Digits appear in the pointer when the climb or descent rate is greater than 100 fpm. If the rate
of ascent/descent exceeds 4000 fpm, the pointer appears at the corresponding edge of the tape and the rate
appears inside the pointer.
A magenta chevron bug is displayed as the Required Vertical Speed Indication (RVSI) for reaching a VNV
Target Altitude once the “TOD [Top of Descent] within 1 minute” alert has been generated. See the Flight
Management Section for details on VNV features, and refer to Section 2.2, Supplemental Flight Data, for more
information about VNV indications on the PFD.