Additional features, Horizon heading, Traffic – Garmin G1000 King Air C90GT User Manual

Page 472: Airport signs

Advertising
background image

Garmin G1000 Pilot’s Guide for the Hawker Beechcraft C90A/GT

190-00663-01 Rev. A

458

ADDITIONAL FEATURES

SY

STEM

O

VER

VIEW

FLIGHT

INSTRUMENTS

EIS

AUDIO P

ANEL

& CNS

FLIGHT

MANA

GEMENT

HAZARD

AV

OID

ANCE

AFCS

ADDITIONAL FEA

TURES

APPENDICES

INDEX

HORIZON HEADING

The Horizon Heading is synchronized with the HSI and shows approximately 60 degrees of compass

heading in 30-degree increments on the Zero Pitch Line. Horizon Heading tick marks and digits appearing
on the zero pitch line are not visible behind either the airspeed or altitude display. Horizon Heading is used
for general heading awareness, and is activated and deactivated by pressing the HRZN HDG Softkey.

TRAFFIC

WARNING:

Intruder aircraft at or below 500 ft. AGL may not appear on the SVS display or may appear as a

partial symbol.

Traffic symbols are displayed in their approximate locations as determined by the related traffic systems.

Traffic symbols are displayed in three dimensions, appearing larger as they are getting closer, and smaller
when they are further away. Traffic within 1000 feet laterally of the aircraft will not be displayed on the SVS
display. Traffic symbols and coloring are consistent with that used for traffic displayed in the Inset map or
MFD traffic page. If the traffic altitude is unknown, the traffic will not be displayed on the SVS display. For
more details refer to the traffic system discussion in the Hazard Avoidance section.

AIRPORT SIGNS

Airport Signs provide a visual representation of airport location and identification on the synthetic terrain

display. When activated, the signs appear on the display when the aircraft is approximately 15 nm from
an airport and disappear at approximately 4.5 nm. Airport signs are shown without the identifier until
the aircraft is approximately eight nautical miles from the airport. Airport signs are not shown behind the
airspeed or altitude display. Airport signs are activated and deactivated by pressing the APTSIGNS Softkey.

Figure 8-8 Airport Signs

Airport

Sign with

Identifier

(Between

4.5 nm and

8 nm)

Airport

Sign

without

Identifier

(Between

8 nm and

15 nm)

Traffic

Advertising
This manual is related to the following products: