8 procedures, Departures, Flight management – Garmin G1000 King Air C90GT User Manual

Page 251: Loading a departure into the active flight plan

Advertising
background image

190-00663-01 Rev. A

Garmin G1000 Pilot’s Guide for the Hawker Beechcraft C90A/GT

237

FLIGHT MANAGEMENT

SY

STEM

O

VER
VIEW

FLIGHT

INSTRUMENTS

EIS

AUDIO P

ANEL

& CNS

FLIGHT

MANA

GEMENT

HAZARD

AV

OID
ANCE

AFCS

ADDITIONAL

FEA
TURES

APPENDICES

INDEX

5.8 PROCEDURES

The G1000 can access the whole range of instrument procedures available. Departures (DPs), arrivals (STARs),

and non-precision and precision approaches (APPRs) are stored within the database and can be loaded using any
Procedures (PROC) Key.

The selected procedure for the departure or arrival airport is added to the active flight plan. No waypoints are

required to be in the active flight plan to load procedures; however, if the departure and arrival airport are already
loaded, the procedure loading window defaults to the appropriate airport, saving some time selecting the correct
airport on the Procedure Loading Page. Whenever an approach is selected, the choice to either “load” or “activate”
is given. “Loading” adds the approach to the end of the flight plan without immediately using it for navigation
guidance. This allows continued navigation via the intermediate waypoints in the original flight plan, but keeps
the procedure available on the Active Flight Plan Page for quick activation when needed. “Activating” also adds
the procedure to the end of the flight plan but immediately begins to provide guidance to the first waypoint in
the approach.

DEPARTURES

A Departure Procedure (DP) is loaded at the departure airport in the flight plan. Only one departure can be

loaded at a time in a flight plan. If a departure is loaded when another departure is already in the active flight
plan, the new departure replaces the previous departure. The route is defined by selection of a departure, the
transition waypoints, and a runway.

LOADING A DEPARTURE INTO THE ACTIVE FLIGHT PLAN

Loading a departure into the active flight plan using the PROC Key:

1)

Press the PROC Key. The Procedures Window is displayed.

2)

Highlight ‘SELECT DEPARTURE’.

3)

Press the ENT Key. The Departure Loading Page is displayed.

4)

Select a departure from the list and press the ENT Key.

5)

Select a runway (if required) and press the ENT Key.

6)

Select a transition (if required) and press the ENT Key. ‘LOAD?’ is highlighted.

7)

Press the ENT Key to load the departure procedure.

Advertising
This manual is related to the following products: