System menu: “call forwarding, The device menu – AASTRA 600d for Aastra 800 and OpenCom 100 User Guide EN User Manual

Page 120

Advertising
background image

The Device Menu

118

HG no: [internal call number]: The pick-list of hunt group call numbers

appears. Activated hunt group calls have a “+” prefixing the hunt group
call number; deactivated ones have a “-”.
On/Off: switching hunt group calls on or off

All: switching all hunt group calls On/Off for your telephone or for the trunk

key selected

Note: If you are the last reachable member of the hunt group and you log out
then any further callers will hear a busy signal. Depending on the system con-
figuration, additional callers can also be forwarded to the exchange.

Device busy: if there are multiple trunk keys configured on your telephone, you can

set that your device is busy as soon as one of the trunk keys is busy. Any subse-
quent callers hear a busy signal.

on/off: switching the function on or off. A “+” indicates the function is

switched on.

System menu: “Call forwarding”

Call diversion: Programming call diversions for your own telephone. If there are mul-

tiple trunk keys configured on your telephone, you can programme call diver-
sions for each of these keys. To do so, select the desired key (e.g. L1: [internal
call number]
) and then press the Ok softkey.

Immediately / After delay / Busy: Select the desired forwarding type.

Dest.: Enter the call number you wish to forward to (for entering the call

number, please refer to the chapter entitled External Seizure and Entry
of Call Numbers starting on page 54
).

Time: When programming call forwarding after time, enter the time in seconds

after which a call is to be forwarded (10 sec … 120 sec). If you do not
enter a value, the default time interval provided by the system adminis-
trator at system configuration is used (default: 20 seconds).

Internal calls / External calls / Int./ext. calls (internal & external calls): Select

which calls are to be forwarded.

On/Off: Switching call forwarding on or off. Active call forwarding is indicated

by a “+” sign. This is followed by the call forwarding destination.

Advertising