AASTRA 600d for Aastra 800 and OpenCom 100 User Guide EN - Manual (Page 136)

The Device Menu
134
times. Then an alarm call can also be made during a call (depending on
mobile unit).
Other systems: The “Hold” function may be generated using other
codes on other systems. The respective system documentation provides
information on suitable programming.
Alarm auto answer: You can configure whether a call from any call number is
automatically answered during a prealarm. No matter what the setting,
calls from the alarm call number or the SOS emergency call number are
automatically accepted and prealarm ended.
Alarm tone: Prealarm can take place with/without an alarm tone on the
mobile unit. When the alarm tone is activated, it is signalled with
increasing volume.
Handsfree in alarm: You can configure whether an alarm call is done in
handsfree or receiver operation. This setting also applies to the emer-
gency call via the SOS/emergency call key.
Pre alarm: You can set the time interval to go by until the emergency call
number is dialled. During this time, there is a ring tone (alarm tone) sig-
nalled at increasing volume (unless deactivated). During the prealarm,
the alarm can still be cancelled (Off, 10 sec … 60 sec).
Repeat alarm: This is the time interval after which another prealarm including
subsequent dialling of the alarm call number is executed, e.g. because
calling the alarm call number was cancelled (Off, 5 sec … 240 sec).
Mandown
Status: Shows whether mandown alarm is switched on or not. Press the
Edit softkey to switch on or off.
Delay: You can define the time how long the device is allowed to be out
of the vertical position without triggering a prealarm (1 sec …
60 sec).
No movement alarm
Status: Shows whether no movement alarm is switched on or not. Press
the Edit softkey to switch on or off.
Delay: You can define the time how long the device is allowed to be
motionless without triggering a prealarm (10 sec … 60 sec).