AASTRA 600d for Aastra 800 and OpenCom 100 User Guide EN - Manual (Page 24)

Commissioning
22
Commissioning
Load the battery before using the mobile unit for the first time because of its low
capacity on delivery. Place the switched on or switched off mobile unit into the
charger. If the mobile unit is switched off (e.g. after inserting the battery for the first
time), the mobile unit will be charged while beeing switched off. The LED flashes alter-
nately green / red to indicate this state. When you switch on the mobile unit (see
page 41), the current charging status is displayed (see page 24).
Maximum battery performance is achieved only after three to five charge and dis-
charge cycles. Place the mobile unit regularly into the charger to charge the battery
optimally.
Charging and Usage Times
Charge time in the charger (uncharged battery):
2.5 hours to full capacity (standard battery), 5 hours (power battery).
Charge time using USB charger:
5 hours to full capacity (standard battery), 10 hours (power battery).
Talk time:
Standard battery – up to 15 hours (at full charge) for North America.
Standard battery – up to 12 hours (at full charge) for other countries.
Power battery – up to 30 hours (at full charge) for North America.
Power battery – up to 24 hours (at full charge) for other countries.
Stand-by time:
Standard battery – up to 105 hours (at full charge) for North America.
Standard battery – up to 110 hours (at full charge) for other countries.
Power battery – up to 190 hours (at full charge) for North America.
Power battery – up to 200 hours (at full charge) for other countries.