AASTRA 600d for Aastra 800 and OpenCom 100 User Guide EN - Manual (Page 20)

Installation
18
Setting Up and Connecting the Charger
Aastra 610d, Aastra 620d: The mobile units can be operated without changing the
charger.
Aastra 630d: When operating the mobile unit,
you have to remove the two lateral guides in the
charger. These are easy to lift up on the inner
edge using a fingernail or a paper clip.
You can also remove the guides by pressing a
suitable screwdriver in the longish holes on the bottom of the
charger.
Connect the power supply unit with the charger and place the connecting cable
through the cable guide. If necessary, change the connector of the power supply (see
Power Supply / Power Supply Unit on page 19).
Where to set it up
Your telephone is made for normal usage conditions. Today’s furniture is coated with a
sheer myriad of lacquers and plastics and treated with various lacquer care products.
It is possible that some of these materials contain components which can attack and
deteriorate the plastic feet of the charging station. The device feet altered by these
foreign substances may leave undesirable marks on furniture surfaces.
For understandable reasons, the manufacturer cannot assume liability for these types
of damage. This is why you should use an anti-slip mat under your charging station –
particularly with furniture that is new or has been freshened up with lacquer care
products.
Note
Please make sure you do not set up the charging station in the space where doors or
windows open: Damage Risk!