Xylem 10 001 262R5 AquaForce Pump Controller - Manual (Page 24)

AQUAFORCE Installation, Operation, and Maintenance 18
Installation
< SELECTION: # >
8 = PASSWORD 0 = EXIT
9 = I/O SETUP
10 =COMMUNICATIONS
Press the
NEXT/( ) key to go to the next screen. The display now shows:
< SELECTION: # >
11 = FRIC. LOSS COMP.
12 = SAVE/LOAD
13 = DISPLAY 0 = EXIT
Pressing the
NEXT/( ) key again will take the screen back to the first screen.
Use the appropriate numeric key to select the desired menu, then press the ENTER key. A detailed description
of each menu follows. For example, to select the STAGE/DESTAGE menu, press the PV/1 key and then press
the ENTER key.
4.10.3 Stage/ destage menu
Paths: Status Screens / Set up(3) / System(4) / StageDestage(1)
The first screen has been displayed below:
SELECTION: #
1 = PV STAGE 0=EXIT
2 = PV DESTAGE
6 = POWER LIMIT STAGE
By pressing the appropriate numeric key and
ENTER key, the setup can be completed.
See the following table for all STAGE/DESTAGE menu items.
STAGE/DESTAGE SETUP MENU ITEMS
Menu Item Variable Default Range Field
Value
PV Stage Stg Spd: ##% 95 0-100
The maximum speed at which the lead pump will
operate prior to starting a lag pump, %.
Stg Proof Timer: ### s 30 0-999
Proof timer prior to starting lag pump, seconds.
Stab Timer: ###s 60 0-999
Staging stabilization time, delay prior to calculating
destage value, seconds.
▲
▲