Xylem 10 001 262R5 AquaForce Pump Controller - Manual (Page 9)

AQUAFORCE Installation, Operation, and Maintenance 3
Introduction and Safety
1.6 User safety
1.6.0 General safety rules
These safety rules apply:
• Always keep the work area clean.
• Pay attention to the risks presented by gas and vapors in the work area.
• Avoid all electrical dangers. Pay attention to the risks of electric shock or arc flash hazards.
• Always bear in mind the risk of drowning, electrical accidents, and burn injuries.
1.6.1 Safety equipment
Use safety equipment according to the company regulations. Use this safety equipment within the work area:
• Helmet
• Safety goggles
• Protective shoes
• Protective gloves
• Gas mask
• Hearing protection
• First-aid kit
• Safety devices
NOTICE:
Never operate a unit unless safety devices are installed. Also see specific information about safety devices in other
chapters of this manual.
1.6.2 Electrical connections
Electrical connections must be made by certified electricians in compliance with all international, national, state,
and local regulations. For more information about requirements, see sections dealing specifically with electrical
connections.
1.6.3 Precautions during work
Observe these safety precautions when you work with the product or are in connection with the product:
• Never work alone.
• Always wear protective clothing and hand protection.
• Stay clear of suspended loads.
• Always lift the product by its lifting device.
• Beware of the risk of a sudden start if the product is used with an automatic level control.
• Beware of the starting jerk, which can be powerful.
• Rinse the components in water after you disassemble the pump.
• Do not exceed the maximum working pressure of the pump.
• Do not open any vent or drain valve or remove any plugs while the system is pressurized. Make
sure that the pump is isolated from the system and that pressure is relieved before you disassemble
the pump, remove plugs, or disconnect piping.
• Never operate a pump without a properly installed coupling guard.