Xylem 10 001 262R5 AquaForce Pump Controller - Manual (Page 55)

AQUAFORCE Installation, Operation, and Maintenance 49
Maintenance
6.14.20 Service log
Paths: Status Screens / Log(5) / Service Log(5)
The display now shows:
<Selection: # 0=Exit>
1 = Error Log
2 = Operation Hours
3 = Destage Speed
4 = Run Time Setpoint
Press the Next (►) key to see the next display. The display now shows:
<Selection: #0=Exit>
Use the appropriate numeric key to select the desired sub-menu, then press the ENTER key. A detailed
description of each sub-menu appears.
6.14.21 Error log
Paths: Status Screens / Log(5) / Service Log(5) / Error Log(1)
The display now shows:
MMDD HHMM Error Code
MMDD HHMM Error Code
MMDD HHMM Error Code
MMDD HHMM Error Code
6.14.22 Operation hours
Paths: Status Screens / Log(5) / Service Log(5) / Operation Hours(2)
The display now shows:
Operating Since
MM/DD/YY HH:MM:SS
Total Hours #####
The start date and time is displayed in the MM/DD/YY and HH:MM:SS format respectively. The total number
of hours that the unit has been in operation is also displayed.
Press
SETUP/3, QUICK ACCESS/6 and ENTER keys together to reset or start the function. Press CLEAR
to exit.
6.14.23 Destage Speed
Paths: Status Screens / Log(5) / Service Log(5) / Destage Speed(3)
The display now shows:
Destage Speed = ### %
It shows the speed at which current lag pump will destage.
6.14.24 Run Time Setpoint
Paths: Status Screens / Log(5) / Service Log(5) / Run Time Setpoint(4)
The display now shows:
MMDD HHMM SP ^More
Up Key Pump Speed Suction vLog
MMDD HHMM SP Info ---------➔ Pump Speed Suction Data
MMDD HHMM SP -------- Pump Speed Suction
MMDD HHMM SP Down Key Pump Speed Suction
Every time setpoint change for friction loss compensation, it gets logged. At the same time it also logs number
of running pump, pump speed & suction pressure. The forty most recent logs will be stored. The date is
displayed in MMDD format and the time in 24 hour HHMM format. The most recent event will be shown first.
Press NEXT/(►) and PREV/(◄ ) to view more log events. Press CLEAR to exit.
➔