Xylem photoLab 6100 VIS - Manual (Page 101)

photoLab
®
6100 VIS Operation
101 ba75847e01 08/2009
1 Select the required method in the
Concentration
mode.
Manual selection of the method
(see section 4.5.5).
2 Open the Timer menu.
The Timer menu is open.
3 If necessary, add a new timer to
the list with [Add].
Note:
The [Add] function key is only
displayed if a method is selected
for which analysis timers were
programmed but are not yet
displayed in the list of timers.
4 Highlight an analysis timer.
5 If necessary, remove the analysis
timer from the list with [Remove].
6 Start the highlighted timer with
[Start].
The status of the timer is Active.
When the specified time interval
has expired, an acoustic signal
sounds and the status changes to
Expired.
7 Stop the highlighted timer with
[Stop].
The status of the timer changes to
Inactive. The acoustic signal is
switched off.
<TIMER>
Timer 04/16/07 9:52
Designation Time Status
User defined timer 00:15:00 Inactiv
A6/25 - 1 00:15:00 Inactiv
Start Stop Remove Add