Xylem photoLab 6100 VIS - Manual (Page 147)

photoLab
®
6100 VIS Operation
147 ba75847e01 08/2009
Note
Make sure the folder structure of the files is retained while the files are
unpacked. If you use a program such as WinZip to unpack the files, the
option, "Nutze Ordnernamen" or "Use Folder Names" must be set. Details
are given in the documentation of the unpack program.
The "Update" folder must be on the top level of the USB memory device. The
Update folder contains several subfolders.
The following steps are carried out at the photometer.
Note
If the update cannot be carried out, an error message is displayed. Check
whether the "Update" folder with its subfolders is stored on the USB memory
device (top level).
3 Connect the USB memory device
to the photometer.
4 Switch on the photometer if
necessary.
5 Using <
▲><▼>, select USB
memory as the source and press
<START·ENTER>.
The update process takes approx.
five minutes.
The photometer switches itself off
and then on again.
<HOME>
[General setup]
– Software/methods update
Software/methods update 04/16/07 9:52
Software/methods update
Select source of update data:
USB memory
PC
Cancel