B&K Precision 4079 - Manual - Manual (Page 24)

18
F4:BURST - (Burst) - Triggers output N cycles for each trigger event, where N ranges from 2 to 999,999.
F5: PHASE - Selects the start phase of the signal in non-continuous modes. The range is from -180˚ to +180˚, with a 0.1˚
resolution. In PHASE mode F2: SET-ZERO sets the phase reference to zero when few instruments are
connected to the same external reference and need to be synchronized with different phase relations.
After selecting the TRIG , GATE or BURST menu, the trigger source menu is available:
Trigger Menu
F1: MAN - Selects manual as the trigger source. To trigger the waveform generator,
press this MAN TRIG again.
F2: INT - Selects the internal trigger generator as the trigger source. Change the
internal trigger rate displayed with the rotary input knob.
F3: EXT - Selects the external trigger signal as the trigger source. The trigger source
is supplied through the TRIG IN connector.
F4: NBRST - Selects the number of burst pulses to be output with each trigger. The N can be changed from 2 to
999,999.
F5:PREV - Goes back to previous menu
3.6.3 WAVEFORM Key
Displays the waveforms available:
Waveform Menu
F1: SINE - Selects the sine waveform.
F2: SQR - Selects the square waveform and displays the waveform duty cycle that can be changed from 20% to 80% up to 10MHz
and 40% to 60% to 30MHz.
F3: TRI - Selects the triangle waveform and displays the waveform duty cycle that can be changed from 10% to 90%. The triangle
maximum frequency is 5MHz.