B&K Precision 4079 - Manual - Manual (Page 80)

74
specified by appending a numeric value, to the MARKer keyword. Maximum MARKER Length 4000 points
Arguments
Type: Numeric
Command Type: Setting or Query
Setting
Syntax: :ARBitrary:MARKer:LENGth<ws><length>
Example: :ARB:MARK:LENG 5
Query
Syntax: :ARBitrary:MARKer:LENGth?
Response: NR1
4.13.4.14 Marker State
:ARBitrary:MARKer:STATe <Boolean>
This command is used to enable or disable the marker.
Arguments
Type: Boolean
Command Type: Setting or Query
Setting
Syntax: :ARBitrary:MARKer:STATe<ws>ON | OFF (or 1 | 0)
Query
Syntax: :ARBitrary:MARKer:STATe?
Response: 0|1
4.13.4.15 Save
:ARBitrary:SAVe
This command is used to save all unsaved arbitrary waveform data into non-volatile memory..
Arguments
Type: none
Command Type: Setting only
Setting
Syntax: :ARBitrary: SAVe
4.13.5 Status Subsystem
This subsystem controls the SCPI-defined status reporting structures, which are the QUEStionable and OPERation status
registers, and the error/event queue. The OPERation status registers are mandated by SCPI, and so are implemented, but are
not used by the hardware. No status is ever reported through them, and they are not detailed in this manual. The following
shows the STATus structure used:
:STATus
:PRESet
:QUEue
[:NEXT]?
:ENABle
:QUEStionable
:CONDition?