B&K Precision 4079 - Manual - Manual (Page 42)

36
You can store up to 49 front-panel setups in a part of non-volatile Flash known as the settings storage memory. When you recall
a stored setup, the front-panel settings change to match the settings in the stored setup. These stored and recalled settings
include the starting address and length of the arbitrary memory that is loaded in the execution memory.
Note: Storing a waveform generator's setup values stores neither waveform nor the execution memory.
Storing Setups
To store the front-panel setup:
1. Press SETUPS to display the menu.
2. Press F3:STORE to select the Store mode.
3. Use the rotary input knob to select a buffer number. Valid buffer numbers range from 1 to 49. Buffer 0 is a
read-only buffer that contains the power-on settings listed in Table 3-2. The waveform generator does not warn you when you store
a setup into a settings buffer that is already occupied.
Note: The waveform generator does not warn you when you store a setup into a settings buffer that is already occupied.
Recalling Setups. To recall stored front-panel setup:
1. Press SETUPS to display the menu.
2. Press F1:RECALL to select the Recall mode.
3. Use the rotary input knob to select a buffer number. Valid buffers numbers range from 0 to 49. Buffer 0 is a
read-only buffer that contains the power-on settings listed in Table 3-2.