Luminex IS Version 2.3 - Manual (Page 76)

Luminex IS Software Manual for Version 2.3
x
MAP Technology
66 PN 89-00002-00-110 Rev. B
Figure 40 Plate Layout Tab, Off-Plate Commands
12. Insert off-plate commands. You can insert off-plate commands
that run after a single well, after a range of wells, or after rows or
columns of wells. The prompt sentence displayed should be
appropriate for your selection. For example, if you select row B,
the prompt “Establish the off-plate commands to run after wells
B1 through B12” appears.
To establish insert off-plate commands, select the desired wells,
then right-click over the plate layout. Select Insert Off-Plate
Cmd(s) from the menu. Select the desired commands and click
OK. The background of the established wells turn green.
To clear insert off-plate commands, select the wells to clear,
right-click on the plate layout and select Clear Selection from
the menu.
13. After you define the information on the General, Bead Set, and
Plate Layout tabs, click OK. Click Cancel to abort.
Each well can have a series of off-plate commands that run before
the next well is read. You can insert preliminary off-plate commands
that run before the first well.
Table 10. Plate Layout Tab - Selection Shortcuts
Click column heading to select entire column.
Click row heading to select entire row.
Click the top left corner of the plate to select entire plate.