Luminex IS Version 2.3 - Manual (Page 91)

x
MAP Technology Luminex 2.3 Software
PN 89-00002-00-110 Rev. B 81
Change Lot Use the Change Lot command to edit the lot that is applied to the
batch currently opened in data analysis.
‹
To change the lot to another available lot:
1. Click Change Lot (Alt + F8), located at the bottom of Analysis
window, to display the Choose Lot dialog box. See Figure 55.
2. The dialog box displays a list of available standard and control
lots that you can apply to a batch. Highlight the desired lot and
click OK to apply the selected lot to the batch opened in data
analysis. Figure 55 shows standard and control. Figure 56 shows
standard only.
Figure 55 Choose Lot Dialog Box—Standard and Control
Figure 56 Choose Lot Dialog Box—Standard Only
3. To create a new lot from this dialog box as an alternate method,
click New Lot and follow the steps in the Create New Lot
procedure on “Create a New Lot” on page 67.