IDEC WindSRV - Manual (Page 137)

136
www.kepware.com
KEPServerEX5 Help
Possible Cause:
The user is attempting to license a driver or component without the Runtime enabled and running.
Solution:
Start the Runtime Service and then re-attempt licensing.
Module '<module>' is unsigned or has a corrupt signature. Runtime references are
limited to demo operation
Error Type:
Warning
Source:
Runtime
Possible Cause:
Runtime attempted to validate a license certificate and failed.
Solution:
1. Ensure that the license subscriptions are updated.
2. Ensure that the drivers or suites being used are properly licensed.
Note:
Until the problem is corrected, the Runtime project will run in Demo mode.
Move object '<group>' to '<group>' failed
Error Type:
Warning
Source:
Runtime
Possible Cause:
An attempt to move a tag or group to another group or device failed because the item is referenced by another object.
Solution:
The object may be referenced by another object, although the user may not have the privileges to make the change.
No device driver DLLs were loaded
Error Type:
Error
Source:
Runtime
Possible Cause:
The drivers may not have been installed or updated when the server was installed.
Solution:
1. Drivers are synchronized with the server build. Drivers from previous builds may not have required changes;
therefore, they cannot be loaded when the server starts. Re-run the server install.
2. The drivers folder is empty; therefore, no drivers could be loaded. Re-run the server install.