General operation system error messages – IDEC WindSRV User Manual
Page 152
151
www.kepware.com
KEPServerEX5 Help
Solution:
Contact Technical support and verify which version should be installed for the version of the server being run. Remove
the driver that is invalid and then restart the server and load the project.
Unable to use network adapter '<adapter>' on channel '<channel name>'. Using
default network adapter
Error Type:
Warning
Source:
Configuration
Possible Cause:
The network adapter specified in the project does not exist on this PC. Thus, the server will default to using the default
network adapter.
Solution:
Select the network adapter that will be used on the PC and then save the project.
See Also:
Channel Properties - Network Interface
Validation error on '<tag name>': Invalid scaling parameters
Error Type:
Warning
Source:
Configuration
Possible Cause:
An attempt was made to set invalid scaling parameters on the specified tag.
Solution:
Correct the scaling parameters and then save the tag.
General Operation System Error Messages
The following error/warning messages may be generated. Click on the link for a description of the message.
General Operation System Error Messages
Dialing '<phone number>' on line '<modem name>'
Dialing aborted on '<modem name>'
Dialing on line '<modem name>' cancelled by user
Failed to open modem line '<modem name>' [TAPI error]
Hardware error on line '<modem name>'
Incoming call detected on line '<modem name>'
Line '<modem name>' connected at '<baud rate>' baud