Yokogawa ADMAG AXF - Manual (Page 77)

IM 01E20C01-01E 8-1
8. OPERATION VIA HART COMMUNICATOR TOOL (HART 5)
NOTE
This chapter describes the AXFA11 as an
example.
Note: HART is a registered trademark of the HART
Communication Foundation.
8.1 Matching of instru-
ment (AXFA11) DD
and HART Configura-
tion Tool’s DD
Before using the HART Configuration Tool (such as
FieldMate), confirm that the DD (Device Description)
of the AXFA11 is installed in the Configuration Tool
before using.
About the DD, use the device type, device revision and
DD Revision shown in follows.
Model Name DTM Name Device Type Device
Revision
AXFA11 AXFA11
V1.1 AXFA11
(0x0050) 1
T0801.EPS
The DD revisions for AXFA11 and Configuration
Tool’s can confirm in accordance with the following
steps.
If the correct DD is not installed in the HART Con-
figuration Tool, download them from the official
HART programming sites, otherwise, contact the
respective vendors of the Configuration Tool for its
upgrade information.
1. Confirmation of the device revision for AXFA11
(1) Connect the Configuration Tool to the
AXFA11. The device revision can be checked
as follows.
DD Device Setup
→ Review → Review4
→ Fld dev rev
DTM Confi guration → HART → Fld dev rev
T0802.EPS
2. Confirmation of the device revision for the HART
Configuration Tool
(1) Turn on the power of the Configuration Tool
under the standalone condition.
(2) Confirm the installed DD revision in accor-
dance with the procedure of the Configuration
Tool. Refer to its manual how to confirm it in
detail.
The first 2 digits of the DD file are expressed
the device revision, and its last 2 digits are
expressed the DD revision.
01 03.XXX
DD revision
Device revision
F0801.EPS
8. OPERATION VIA HART COMMUNICATOR TOOL (HART 5)