Yokogawa EJX430B User Manual
Page 49
<8. Setting Parameters>
8-11
IM 01C27B01-01EN
(2) Menu Tree
The menu tree of the device configuration tool of our recommendation is shown below. Refer to Subsection 9.2
“Calibration Instruments Selection” for the device configuration tool of our recommendation.
(a) Integral antenna type (Amplifier housing code: 7)
• UAPMO
• TRANSDUCER
• AI1 DP
• AI2 SP
• AI3 Temp
• Device Configuration
• Diagnostic
• Process Variable
(Device Configuration)
Online Menu
F0803-1.ai
• Configure/Setup
(UAPMO)
• Configure/Setup
(TRANSDUCER)
• UAP Option
• Hardware Write Protect
• Static Revision
• Reset Energy Left
• Radio Silence
(Configuration)
• Version Revision
• CTS Version
• ITS Version
• Identification Number
(Identification)
• Auto Recovery
• Model
• Sensor Serial Number
• Measurement Rate
• Measurement Mode
• Wireless Status
• Display Selection
• LCD Mode
• Special Order ID
• Unit Sel1
• Display Unit1
• EJX Key
• Test Key 1
• Test Key 2
• Test Key 3
(Configuration/Calibration)
• Tag Description
(Block Info)
• Configure/Setup
(AI1 DP)
• Mode.Target
• Mode.Actual
• Mode.Permitted
• Mode.Normal
(Block Mode)
• Block Mode
• Concentrator OID
• Scale *
• Process Value Filter Time
(Configuration)
• Block Mode
• Cal Cmd *
• Cal Status
• Calibration Highest Point *
• Calibration Lowest Point *
• Calibration Minimum Span
• External Zero Trim *
(Calibration)
• Mode.Target
• Mode.Actual
• Mode.Permitted
• Mode.Normal
(Block Mode)
• Upper Limit
• Lower Limit
• PV Range *
• Linerization Type *
• Flow Constant *
• Lower cutoff
• Low Cut Mode *
• H/L Swap *
• T Zero Cmp *
• Temp Zero *
• Temp Select *
(Others)
• PV Range.EU at 100% *
• PV Range.EU at 0% *
• PV Range.Units Index *
• PV Range.Decimal*
(PV Range)
• Mode.Target
• Mode.Actual
• Mode.Permitted
• Mode.Normal
(Block Mode)
• Scale.EU at 100% *
• Scale.EU at 0% *
• Scale.Units Index *
• Scale.Decimal *
(Scale)
• Tag Description
(Block Info)
• Special Cmd
(Others)
*:
When the data of these parameters is rewritten, it is necessary to set the operational mode of the block to O/S (Out of Service).