Yokogawa YFGW410 - Manual (Page 52)

<D1. Engineering Procedures>
D1-3
IM 01W02D01-01EN
n (3): Engineering of the Host System
This task is the engineering of the host (control/monitoring) system by the system engineer.
The task targets system applications for which process data can be read/written using Modbus,
as well as applications for which the process values and parameters of the field wireless device
can be read/written using the ISA100.11a protocol.
Some examples of target applications are shown below.
Modbus/TCP STARDOM, FA-M3R, DAQWORX, DAQSTATION, DAQMASTER,
CENTUM VP, FAST/TOOLS, other companies’ implementations of DCS/
SCADA
Modbus/RTU DAQMASTER and other companies’ implementations of DCS/SCADA
ISA100.11a PRM, FieldMate
OPC Applications that correspond to OPC servers (CENTUM VP, FAST/
TOOLS, etc.)
For details, see the User’s Manual for the relevant host system.
IMPORTANT
When CENTUM VP R4 is used, R4.02.30 or higher is required. For details, see Reference Sub-
system Communication (Using FIO) (IM 33M01A30-40E).
When CENTUM VP R5 is used, R5.02.00 or higher is required.
If CENTUM VP is used with YFGW410 in redundant configuration or writing output values to field
wireless devices, CENTUM VP R5 is required. For details, see the Communication with Subsys-
tem Using FIO user’s manual (IM 33K03L20-50E).