Yokogawa YFGW410 - Manual (Page 63)

<D3. Constructing a Field Wireless System>
D3-2
IM 01W02D01-01EN
D3.2 Detail of Configuration
This section describes the setting operation items and the procedure to configure a field wireless
network using the Configurator of the Field Wireless Management Console.
D3.2.1 YFGW410 Settings
n Device tag and redundancy setting
In the initial window of the Configurator (Figure D2-3), set the YFGW410 Device Tag and whether
to use the Layer2 switch with the Field Wireless Backbone Network (between the YFGW410 and
YFGW510) when YFGW410 is set to redundant operation.
The character input restrictions for device tags and the factory default setting are shown below.
When editing a device tag, obey these restrictions.
Item Description Input character restrictions Default setting
Device Tag Device Tag Up to 16 characters of following types: half-
byte uppercase alphanumeric characters,
hyphens, and underscores
YFGW410
The [Enable Redundancy] check box indicates redundancy of the YFGW410. It determines and
displays single or redundant operation based on the connection status of the cable for redundan-
cy or terminator connected to the Synchronization connector of the YFGW410.
Item Description Status of YFGW410 Check box
Enable
Redundancy
YFGW410 operation mode
setting
Single operation Check box cleared
Redundant operation Check box selected
In addition, the [Use external Layer2 switch for Field Wireless Backbone Interface] check box in-
dicates the use of the Layer2 switch. The default setting is displayed according to the YFGW410
redundancy settings. When the Layer2 switch is used with the Field Wireless Backbone Network,
always select the check box while observing the important points listed in Chapter A4.YFGW410
in High-Level Redundancy Configuration.
Settings for the [Use external Layer2 switch for Field Wireless Backbone Interface] check box
Status of YFGW410
Check box
Initial value
Actual configuration
Layer2 switch present
No Layer2 switch present
(direct connection)
Single operation Check box cleared Check box cleared (cannot be changed)
Redundant operation Check box selected Check box selected Check box cleared
IMPORTANT
When the setting information of this window is edited, all backbone devices must be restarted
when the setting information is downloaded.