Yokogawa EJX530B - Manual (Page 35)

<8. Setting Parameters>
8-2
IM 01C27F01-01EN
Table 8.1 Parameter Usage and Selection
Item Description
Tag No Sets the tag No. as Device Tag (Software Tag). Sixteen characters
(alphanumeric characters, including - and •) can be set.
Output The process variable and the diagnostic result can be output.
Either or all of differential pressure (AI1:Process Value), static pressure
(AI2:Process Value), temperature(AI3:Process Value) of capsule or
amplifier and self-diagnostic information (UAPMO:Diagnostic Status) can
be set to the output
Range Adjust the range corresponding for 0% to 100%.
The unit of the range, input value at 0% (LRV) and input value at 100%
(URV) is set.
Note: LRV and URV can be set within the range of -32000 to 32000.
Damping time constant Damping time constant is used to reduce the large fluctuation of pressure
signal and given by each Process Value Filter Time parameter for
differential Pressure/pressure (AI1) and Static pressure (AI2).
Output signal low cut mode Used mainly to stabilize output near 0 if output signal is the square root
mode. Two modes are available: forcing output to 0% for input below a
specific value, or changing to proportional output for input below a specific
value.
Integral indicator range of scale and unit Sets one of pressure value, or temperature value for the integral indicator
scale.
Note: LRV and URV can be set within the range of -32000 to 32000.
Unit for displayed temperature Sets a temperature unit to be displayed.
Range with actual input applied Range corresponding for 0% to 100% signal is set with actual input
applied.
The output setting can be done just 100% to user’s reference pressure
output.
However, when shipping it, the calibration is done in high accuracy as for
DPharp. Please do the span setting by a usual range setting.
Zero Point Adjustment and Span Adjustment Handle Zero Point Adjustment and Span Adjustment.
There are two methods of Zero Point Adjustment, using external zero-
adjustment screw and using device configuration tool.
Reset adjustment The amount of the adjustment set by user can be cleared.
Software write protect Prohibit writing the setting data.
Operational mode Set the operational mode of the sensor and integral indicator, etc.
Note: Some of the parameter settings are in a dialogue form called method, the on-line instructions you can configure the parameters
easily.
8.3.2 Function Block and Menu Tree
(1) Function Block
The function of this transmitter is shown below.
A specific function might not be able to be used
according to the field wireless configuration tool
used. When the field wireless configuration tool
of our recommendation is used, the software
attached to the Field Wireless Integrated Gateway
is necessary for setting the dotted line part.
Refer to Subsection 9.2 “Calibration Instruments
Selection” for the field wireless configuration tool
of our recommendation. The setting of differential
pressure(Al2 block) is invalid in this instrument. The
output value of Al2 object and the output status are
“0.0”(zero), “Uncertain” respectively.