Yokogawa EJX530B - Manual (Page 48)

<8. Setting Parameters>
8-15
IM 01C27F01-01EN
• Configure/Setup
(AI2 SP)
F0803-5.ai
• Tag Description
(Block Info)
• Upper Limit
• Lower Limit
• PV Range *
• Linerization Type *
• Flow Constant *
• Lower Cutoff
• Cal Cmd *
• Cal Status
• Calibration Highest Point
• Set Calibration Highest Point *
• Calibration Lowest Point
• Set Calibration Lowest Point *
• Calibration Minimum Span
• Static Pres Type *
• SP Select *
(Others)
• Mode.Target
• Mode.Actual
• Mode.Permitted
• Mode.Normal
(Block Mode)
• Sensor Range.EU
at 100%
• Sensor Range.EU
at 0%
• Sensor Range.Units
Index *
• Sensor Range.
Decimal *
(Sensor Range)
(Block Mode)
• Mode.Target
• Mode.Actual
• Mode.Permitted
• Mode.Normal
(AI3 Temp) (Block Info)
• Tag Description
• Sensor Range
• Tertiary Value Sel *
(Others)
• Block Mode
• Concentrator OID
• Scale *
• Process Value Filter Time
(Configuration)
• Mode.Target
• Mode.Actual
• Mode.Permitted
• Mode.Normal
(Block Mode)
• Scale.EU at 100% *
• Scale.EU at 0% *
• Scale.Units Index *
• Scale.Decimal *
(Scale)
• PV Range.EU at
100% *
• PV Range.EU at
0% *
• PV Range.Units
Index *
• PV Range.
Decimal *
(PV Range)
• Configure/Setup
• Block Mode
• Concentrator OID
• Scale *
• Process Value Filter Time
(Configuration)
• Mode.Target
• Mode.Actual
• Mode.Permitted
• Mode.Normal
(Block Mode)
• Scale.EU at 100% *
• Scale.EU at 0% *
• Scale.Units Index *
• Scale.Decimal *
(Scale)
Menu (Online)
(continued)
Device Configuration
(continued)
*: When the data of these parameters is rewritten, it is necessary to set the operational mode of the block to O/S (Out of Service).