Triton FT7000XP User Manual - Manual (Page 130)

120
M
ODEL
FT7000 XP U
SER
M
ANUAL
E
NTER
M
AINTENANCE
! ! ! ! !
S
END
S
UPPLY
S
TATUS
O
NLY
. When selected, the terminal will send an unsolicited message, status code
‘320’, to the host when the maintenance function is entered. This is the default selection.
! ! ! ! !
Send Supervisory Status Only. When selected, the terminal will send an unsolicited message, status
code ‘340’, to the host when the maintenance function is entered.
! ! ! ! !
Send Supervisory/Supply Status. When selected, the terminal will send two (2) unsolicited messages,
status code ‘320’ and ‘360’, to the host when the maintenance function is entered.
E
XIT
M
AINTENANCE
When the user exits maintenance, the terminal will send an unsolicited message, status code ‘300’, to the
host.
When finished configuring the general parameters, press <6> on the keypad to save parameters and exit.
6. S
ET
Z
ERO
PANLN
TO
1F (Default: Enabled). This function allows the terminal operator to enable/
disable this selection. When “enabled”, the FIT Table PAN length of zero (0) is automatically set to
“1F”. This is required for some networks to successfully send the correct encrypted PIN.
Press <6> on the keypad to toggle either enable (check) or disable (uncheck).
7. R
ESTRICT
W
INDOWS
A
CCESS
S
TATUS
(Default: Enabled). This function allows the terminal operator to
enable/disable this selection. When “enabled”, it prohibits use of the PC keyboard to access any of
the Windows XP functions. Only the keys used for Management function options will be enabled.
Press <7> on the keypad to toggle either enable (check) or disable (uncheck).
8. S
AVE
G
ENERAL
P
ARAMETERS AND
E
XIT
. Allow user to save all the displayed settings and exit from menu.
Press <8> on the keypad to save and exit.