Triton FT7000XP User Manual - Manual (Page 36)

26
M
ODEL
FT7000 XP U
SER
M
ANUAL
I
NSTALLING
N
OTE
C
ASSETTE
:
Using the reverse of the steps used to remove the note cassette from the mechanism, slide the note cassette
into its slot in the mechanism. Keep the cassette level as you load it, and make sure the cassette is fully
inserted. Once all cassettes have been filled and reinserted, they are ready to be <Locked> into position
following the Replenish Cassette(s) function prompts.
* NOTE *
Before locking cassettes, it is recommended to check the Reject Cassette for
any rejected notes. The procedures for the reject cassette are described next.
R
EMOVING THE
R
EJECT
C
ASSETTE
:
*IMPORTANT*
If you remove the reject cassette with power applied, the terminal
will sense this and automatically reset the rejected note count to
ZERO. Therefore, to ensure an accurate rejected note count NEVER
REMOVE THE REJECT VAULT WITH POWER APPLIED WITH-
OUT CHECKING FOR AND REMOVING ANY REJECTED NOTES!
1. Ensure cassettes are <Unlocked>. To remove the reject cassette, (top channel) grasp the cassette
handle with one hand while holding the mechanism in place with the other hand. Pull the cassette out
slightly. Place one hand underneath to support the cassette as you slide it completely out of the unit.
Place it on a level surface (Figures 3-22 and 3-23).
Figure 3-22. Removing the reject vault. Figure 3-23. Reject vault ready to open.