Triton FT7000XP User Manual - Manual (Page 35)

25
R
EPLENISHING
C
ASSETTES
• Slanting pile
To avoid dispensing problems caused by a “slant-
ing” pile, put the notes in neat bundles of no more
than ½ to ¾ inches in thickness. Turn every other
bundle around to minimize slanting of the pile.
2. Level the note pile. Compress the note pile slightly by hand. Single notes must not protrude from the
bundle (Figure 3-19).
• Cupped bundle
To avoid dispensing problems caused by cupped
bundles, turn all the bundles with the cupped side
towards the dispense opening.
• Common notes
Place the prepared bundles in the cassette.
Figure 3-19. Leveling note pile.
3. Move the pusher plate against the notes with just enough pressure to hold the notes in the correct
position when closing the lid and inserting the cassette into the mechanism (Figure 3-20).
Figure 3-20. Moving pusher plate against notes.
4. Move the white plastic levers (Pawls) on the pusher plate to their fully extended position. This will
allow the pusher plate to retract and release pressure from the note stack when an unlock command
is sent to the dispenser (Figure 3-21).
Figure 3-21. “Pawls” extended.
5. Close the cassette lid. Fold the lid down to its locked position. The release button should “pop” out,
allowing the lid to mate cleanly with the body of the cassette. You may need to “tap” the lid firmly along
the front edge to achieve this. Turn the key counterclockwise to lock the cassette.