Badger Meter SRD/SRI Valve Positioners - Manual (Page 35)

Calibration Information
This is a 14-byte field that is a pure scratch area . It is initialized to "Message 5" and it is user definable . It is intended for a short
note that needs to be written into the positioner EPROM that reflects when and who did the last calibration on the positioner .
When a calibration is requested from the software, this field automatically opens-up to allow the user to enter data .
Fabrication Number
This is a 4-byte number that is permanently set at the factory . It is the unique positioner fabrication number and can be used
to ferry information back to the factory about issues with the positioner in the field . It is used for tracking the positioner .
Hardware Revision
This single byte field is preset at the factory to show the revision of the electronics within the positioner . It is currently set to
zero (that is, Revision 0 electronics) .
Configuration / Parameter
Page 35 August 2014 POS-UM-00011-EN-02