NORD Drivesystems BU0510 - Manual (Page 44)

POSICON position control for NORD frequency inverters, SK 530E and above
44 Subject to technical alterations BU 0510 GB-3911
Value Function Description Signal*
20 Referenz Reference point is available / has been saved High
21 Position reached Setpoint position has been reached High
22 Comparative position Position value in P626 has been reached High
23 Comparative position
value Position value in P262 without consideration of sign has been reached High
24 Position array value A value set in P613 has been reached or exceeded. High
25 Comparative position
reached Comparative position has been reached, as for 22 with consideration of
P625 High
26 Comparative position
value reached Comparative position value has been reached, as for 23 with
consideration of P625 High
27 Drive in synchronous
operation The slave drive has completed the start phase of the "Flying Saw"
function and is now synchronised with the master axis. High
* For relay contacts (High = "Contact closed", Low = "Contact open")
Parameter
{factory setting}
Setting value / Description / Note Device Supervisor Parameter set
P441
Relay 2 function
(Function of output 2 (Relay 2 – MFR1))
up to SK 535E P
0 ... 39
{ 7 }
Control terminals 3/4: Functions are identical to P434!
P450
Relay 3 function
(Function of output 3 (DOUT1) )
From SK 520E
to SK 535E
P
0 ... 39
{ 0 }
Control terminals 5/40: Functions are identical to P434! Digital output, 15V against DGND (for
SK 5x5E devices, deviations of the signal level are possible (see BU0500)).
P455
Relay 4 function
(Function of output 4 (DOUT2))
From SK 520E
to SK 535E
P
0 ... 39
{ 0 }
Functions are identical to P434! Digital output, 15V against DGND (for SK 5x5E devices,
deviations of the signal level are possible (see BU0500)).