Sterlco SDAP 90-225 CFM Series Drying and Conveying Systems - Manual (Page 15)

SDAP Series PD 2 to PD 4 Drying and Conveying Systems Page 15
3 Installation
3-1 Work Rules
The installation, operation, and maintenance of this equipment must be conducted in accordance
with all applicable work and safety codes for the installation location. This may include, but is
not limited to, OSHA, NEC, CSA, and any other local, national, and international regulations.
• Read and follow these operating instructions when installing, operating, and maintaining
this equipment. If the instructions become damaged or unreadable, additional copies are
available from Sterling.
• Only qualified personnel familiar with this equipment should work on or with this dryer.
• Work with approved tools and devices.
• Disconnect the electricity before maintenance or service. If the dryer is installed with a
power cord that can be unplugged, unplug it. If the dryer is permanently wired to a power
main, a fused power disconnect must be installed to allow the disconnect to be locked in
the
OFF position. Open and lock out the disconnect installed in the control enclosure.
3-2 Positioning Your SDAP System
The SDAP system was designed to be wheeled into place. The entire assembly is mounted on a
rugged, compact frame with an integral handle. The cart is equipped with sturdy, 6” (15 cm)
heavy duty casters, two locking and two swivel.
Caution!
Use caution and observe safety rules when placing your cart!