Sterlco SDAP 90-225 CFM Series Drying and Conveying Systems - Manual (Page 44)

Page 44 SDAP Series PD 2 to PD 4 Drying and Conveying Systems
4-15 Optional Seven Day Timer
The seven-day timer can be programmed for daily or weekly (over midnight) on/off operation.
An internal battery back up holds the settings in memory when the dryer is de-energized.
h
m
SHIFT
SET/RESET
DAY
PROG
OUT
CHECK WRITE
TIME ADJ
P1
P2
RUN
AUTO
ON
OFF
OUT 1 2
COPY CYCLE/PULSE TIMER 1 2 MAN
PULSE 1 2 AUTO
MODE BOOT
CLR
(1) SHIFT key
(2) SET/RESET key
(3) h key
(5) CHECK key
(12) OUT switch
(4) m key
(6) WRITE key
(11) MODE switch
(10) CLR key
(7) TIME ADJ key
(9) COPY key
(8) CYCLE/PULSE key
(13) TIMER/PULSE switch (14) MAN/AUTO RESET switch
THU MON SUN TUE WED SAT FRI
S
m
AM
P M
AM
PM
S
m
P M
AM
2
1 1
2
PM
AM
1
SUN MON
P M
FRI WED TUE THU SAT
1
Day indicator
Cursor
Main display
Pulse width indicator
Indicator for number
of remaining steps
Set circuit
number indicator Timing chart display
Time adjustment
mode indicator
Power failure indicator
Output circuit indicator
Display
Timer
(15) Output indicator
(16) Timing chart display
No. Function
1 Shifts the cursor (
∇) specifying a day to the right.
2 Sets or cancels (reset) a specified day.
3, 4 Sets a time or ON/OFF time width. (hours, minutes)
5 Monitors the parameters set for an operation during an operation.
6 Sets parameters. (Write)
7 Sets a time adjustment mode.
8 Specifies a cyclic operation, or sets a pulse width. (Not used)
9 Specifies a day substitution operation. (Copy)
10 Cancels the parameters set for each circuit, or a day substitution operation.
11
P1: Circuit 1 programming mode.
P2: Circuit 2 programming mode.
Run: Run mode.
12
ON: Turns on the output regardless of the program
AUTO: Executes according to the program.
OFF:
Turns off the output regardless of the program.
13
TIMER: Executes an ordinary timer or cyclic operation.
PULSE: Executes a pulse-output operation.
14 Specifies automatic or manual operation following a power failure.
15 The Output indicator will light when the timer output is energized. (Dryer On)
16 Displays the time at which the next operation will be preformed.