Checking the set time – Sterlco SDAP 90-225 CFM Series Drying and Conveying Systems User Manual
Page 46
Page 46
SDAP Series PD 2 to PD 4 Drying and Conveying Systems
3. Press the
SET
key (#2).
4. Set the desired start time by pressing the
h
key (#3) to adjust the hour. Holding this key
will rapidly advance the hour.
5. Press the
m
key (#4) to adjust the minutes.
6. Press the
WRITE
key (#6) to store the start time in the timer memory.
7. Next, set the stop time by using the
h
and
m
keys, then press
WRITE
.
8. Turn the
MODE
switch (#11) to run.
Multiple-Day Operation
Multiple day operation will start the dryer on one day and run continuously for several days
before stopping the dryer.
1. Turn the
MODE
switch (#11) to
P1
.
2. Select the desired start day with the
SHIFT
(#1) and
SET
keys (#2).
3. Set the start time with the
h
and
m
keys.
4. Press the
WRITE
key (#6) to store the dryer startup hour in the timer memory.
5. Next cancel the day that was just set by using the
RESET
key (#2).
6. Now select the stop day by using the
SHIFT
(#1) and
SET
key (#2).
7. Set the stop time with the
h
and
m
keys.
8. Press the
WRITE
key (#6).
9. Turn the
MODE
switch (#11) to
RUN
.
Checking the Set Time
The set times can be checked in the sequence the timer is to operate.
1. Press the
CHECK
key (#5). Each time the key is pressed the operation schedule is
displayed in the time sequence.
2. If the time switch is left untouched for 20 seconds during check, the display
automatically returns to
RUN
mode.