Sterlco SDAP 90-225 CFM Series Drying and Conveying Systems - Manual (Page 26)

Page 26 SDAP Series PD 2 to PD 4 Drying and Conveying Systems
3-13 Making Electrical Connections
; Fulfill all national, state, and local safety and electrical code requirements.
; Connections should be made by a qualified electrician.
; Make sure all electrical connections are tight.
; Connect main power to the dryer at the disconnect or terminals in the upper right corner of
the control enclosure.
; Install a fused disconnect with a lockout feature in the power main leading to the dryer.
; The power drop must include a ground wire.
; Make sure quick disconnect cables are connected at the junction boxes on the sight glass
loader (Machine Loader) and the optional vacuum hopper (drying hopper loader).
Figure 9
Typical Quick Disconnect Cable Connections
DRYING HOPPER
LOADER
LOADER
MACHINE
! WARNING !
Proper grounding of the main power line is critical!