HP XP Continuous Access Software - Manual (Page 117)

◦ 10 is recommended if the line speed is from 10 Mbps to 99 Mbps.
◦ 100 is recommended if the line speed is from 100 Mbps to 255 Mbps.
◦ 256 is recommended if the line speed is 256 Mbps and more.
CAUTION: This setting does not take effect on master journal groups. However, if you use
the XP RAID Manager horctakeover command to change a master journal group to a
restore journal group, this setting takes effect on the journal group.
•
JNL Volumes: List of registered journal volumes.
Parity Group: Parity group where a journal volume belongs. ◦
◦ CU:LDEV: Journal volume's CU and LDEV number. The CU number appears to the left of
the colon (:). The LDEV number appears to the right of the colon.
◦ Capacity (GB): Journal volume's capacity in gigabytes.
◦ Emulation: Journal volume's emulation type.
◦ CLPR: Number and name of the CLPR where the journal volume belongs.
•
Mirrors: List of mirrors.
Mirror ID: Mirror ID. This column is blank if the journal group's attribute is neither Master
nor Restore. ◦
◦ Attribute: Mirror ID's attribute.
Initial: Mirror in initial status. No data volumes are registered in the journal groups
of the local array. –
– Master: Mirror to which primary data volumes of the local array are registered.
– Restore: Mirror to which secondary data volumes of the local array are registered.
Displaying detailed information about journal groups 117