HP XP Continuous Access Software - Manual (Page 148)

4. In the list, right-click the pair you want to delete.
5. Select Pairsplit-S. The Pairsplit-S pane ( Figure 65 (page 148) ) appears.
6. Select the options for the pairs.
7. Click Set.
8. In the Preset list on the Pair Operation pane, check the settings you made.
•
To modify a setting, right-click the setting, and select Modify.
•
To cancel a setting, right-click the setting, and select Cancel.
9. Click Apply to restore pairs.
NOTE: If an error occurs, the right-most column of the Preset list displays the error code. To
view detailed information about the error, right-click the error code, and select Error Detail.
An error message appears providing detailed information about the error.
10. In the list on the Pair Operations pane, verify that the pairs were successfully deleted. If the
pair was deleted, the status of the pair is SMPL.
To monitor the progress of deleting pairs, click Refresh to update the information in the list,
or use the Pairdisplay pane (see
Displaying detailed information about a pair of data volumes )
to monitor the detailed status of each pair.
NOTE: To restore a pair that was deleted from the secondary array, delete the pair from the
primary array, and restore the pair using the appropriate initial copy option.
NOTE: If a pair is deleted, the deletion might take effect on the secondary data volume later than
it takes effect on the primary data volume. Therefore, an error might occur if you reference a pair's
status or manipulate a pair immediately after XP RAID Manager deletes the pair. If such an error
occurs, check the secondary data volume's status and retry referencing the pair status or
manipulating the pair.
NOTE: After the status of a primary data volume changes to SMPL, the secondary data volume
may remain with the status of PSUS or PSUE in the secondary subsystem. Please select the secondary
data volume and delete the pair.
Figure 65 Pairsplit-S pane
•
Range: Delete range. If you select two or more pairs in the same consistency group, the default
is LU. Otherwise, the default is Group. Also, if the pair status is SMPL, Range is set to LU.
◦ LU: Only the specified pairs are deleted.
148 Performing XP Continuous Access Journal pair operations