HP XP Continuous Access Software - Manual (Page 90)

•
Apply: Applies settings in the Preset list to the arrays.
•
Cancel: Cancels settings displayed in the Preset list.
NOTE: Information on the DKC Operation pane is updated when you do one of the following:
•
Select another tab, and reselect the DKC Operation tab.
•
Click Refresh ( ) (top right of XP Command View Advanced Edition Software or XP Remote
Web Console pane).
•
Click Apply.
•
Select Modify mode when you are in View mode.
•
Open or close the DKC Status pane.
•
Click Refresh on the DKC Status pane.
Displaying information about remote arrays
1. Display the DKC Operation pane.
2. In the Switch Display box, select DKC.
The tree and list display remote arrays.
•
Tree: Lists remote arrays. The following information appears to the right of the icon.
Remote array's controller ID (array family ID). ◦
◦ Remote array's serial number.
◦ Path group ID.
The icon indicates the status of logical paths between the local and remote arrays.
All logical paths are in normal status.
A failure occurred at some logical paths.
•
List: Displays information about remote arrays.
Controller ID: Remote array's controller ID. The controller ID is an array's family ID. The
icon indicates the status of logical paths between the local and remote arrays. ◦
All logical paths are in normal status.
A failure occurred at some logical paths.
NOTE: The controller ID for an XP12000/XP10000 is 4.
◦ S/N: Remote array's five-digit serial number.
◦ Path Gr. ID: Path group ID.
NOTE: In the current version, the path group ID is set to the default value.
◦ M-R Path: Channel type of the logical path between the local and remote arrays. This
column always displays Fibre.
90 Configuring arrays and logical paths