HP XP Continuous Access Software - Manual (Page 118)

◦ Status: Status of a journal group (or a mirror) in the local array.
Journal group in initial status.
Journal volumes are registered in this journal group, but no data volumes
(primary or secondary data volumes) are registered in this journal group.
When creating an XP Continuous Access Journal volume pair, data
volumes are registered in a journal group. The status of the journal group
changes to Active.
Initial
Either of the following:
– Initial copy is in progress. The primary and secondary data volumes
are not synchronized.
– Initial copy is finished. The primary and secondary data volumes are
synchronized.
NOTE: If a journal group is in Active status, some data volume pairs in
the journal group might be split. If this happens, Warning appears. To
restore such data volume pairs, use the Pair Operation pane. For more
information, see
Restoring a pair of data volumes .
Active
An operation for splitting the mirror has started. The status of the mirror
immediately changes to Halting.
NOTE: HaltAccept can indicate the status of restore journal groups, but
cannot indicate the status of master journal groups.
HaltAccept
An operation for splitting or deleting the mirror is in progress. The primary
and secondary data volumes are not synchronized.
When splitting a mirror, the status changes in the following order: Halting,
Halt, Stopping, and finally Stop.
When deleting a mirror, the status changes in the following order: Halting,
Halt, Stopping, Stop, and finally Initial.
Halting
An operation for splitting or deleting the mirror is in progress. The primary
and secondary data volumes are not synchronized. Halt
An operation for splitting or deleting the mirror is in progress. The primary
and secondary data volumes are not synchronized. Stopping
The primary and secondary data volumes are not synchronized. Either of
the following:
– The operation for splitting the mirror is finished.
– The operation for deleting the mirror is in progress.
Stop
an XP Continuous Access Journal pair for delta resync operations is
created. Hold
An error occurred with the XP Continuous Access Journal pair for delta
resync operations. Hold(Failure)
No journal volumes and data volumes are registered in this journal group. Blank
◦ CTG: Number of a consistency group to which the mirror belongs. This column is blank
if there is no consistency group.
◦ S/N: Remote array's serial number. This column is blank if the journal group's attribute
is neither Master nor Restore.
◦ Pair JNLG: Number of a journal group in the remote array. This column is blank if the
journal group's attribute is neither Master nor Restore.
◦ Controller ID: Remote array's controller ID (that is, array family ID). This column is blank
if the journal group's attribute is neither Master nor Restore.
118 Using journal groups