HP XP Continuous Access Software - Manual (Page 109)

– Pairsplit -S: Delete a mirror
– Blank: Nothing occurs when you click Apply
◦ Preset: The number to the left of the slash (/) is the number of items displayed in the Preset
list. The number to the right of the slash is the maximum number of items that can be
displayed in the Preset list. For example, if Preset 010/256 appears, you can add another
246 items to the Preset list.
•
Apply: Applies settings in the Preset list to the arrays.
•
Cancel: Cancels settings in the Preset list.
NOTE: Information on the Journal Operation pane is updated when you do one of the following:
•
Select another tab, and reselect the Journal Operation tab.
•
Click Refresh ( ) (top right of XP Command View Advanced Edition Software or XP Remote
Web Console pane).
•
Click Apply.
•
Select Modify mode when you are in View mode.
Registering journal volumes in journal groups
To perform remote copy operations with XP Continuous Access Journal, the primary site administrator
must register journal volumes in journal groups in the primary array. Also, the secondary site
administrator must register journal volume in journal groups in the secondary array. One journal
group can contain up to 16 journal volumes.
If you are logged onto an XP10000, you can perform this operation only on journal groups that
have a number below 10.
To register journal volumes, the primary and secondary array administrators must perform the
following procedure:
1. Ensure that XP Command View Advanced Edition Software or XP Remote Web Console is in
Modify mode. For more information, see the HP StorageWorks XP Command View user guide
for XP Disk Arrays or the HP StorageWorks XP Remote Web Console user guide for
XP12000/XP10000/SVS200.
2. Display the Journal Operation pane ( Displaying the Journal Operation pane ).
3. In the tree of the Journal Operation pane, do one of the following:
•
To register new volumes to a journal group in which journal groups are already registered,
select the journal group from below Registered.
CAUTION: You can register volumes only when the journal group's attribute is Initial
or the journal group's status is Active, Stop, Hold , or Hold(Failure).
•
To register volumes to a journal group in which journal groups have not been registered,
select the journal group from below Free.
NOTE: You cannot select more than one journal group.
4. Do one of the following:
•
In the tree, right-click the selected journal group, and select Edit JNL Volumes.
•
In the upper-right list, right-click the desired journal group, and select Edit JNL Volumes.
Registering journal volumes in journal groups 109