Pane – HP XP Continuous Access Software User Manual
Page 133
NOTE:
Information on the Pair Operation pane is updated when you do one of the following:
•
Select another tab, and reselect the Pair Operation tab.
•
Click Refresh (
) (top right of XP Command View Advanced Edition Software or XP Remote
Web Console pane).
•
Click Apply.
•
Select Modify mode when you are in View mode.
Filtering information in the list on the Pair Operation pane
Use the Display Filter pane to filter information in the list on the Pair Operation pane. The list
displays only volumes that satisfy certain conditions.
1.
In the Pair Operation pane (
), click Display Filter.
2.
In the Display Filter pane, specify information you want to display in the list.
3.
Click Set to close the Display Filter pane.
NOTE:
•
To restore the list to the default status (that is, the status before filtering), click Reset in the
Display Filter pane, and click Set in the same pane.
•
If you change settings in the Display Filter pane, the changes remain in effect during the XP
Continuous Access Journal session until you reset the settings.
Figure 59 Display Filter pane
•
Port: Port to be displayed. To display all ports, select ALL.
NOTE:
You can specify the port number with two characters. For instance, you can abbreviate
CL1-A to 1A. You can also enter the port number in both lowercase and uppercase characters.
•
G-ID: Group number of the host group or iSCSI target to display. To display all host groups
and iSCSI targets, select ALL.
•
JNL Group: Journal group to be displayed. To display all journal groups, select ALL.
•
Mirror: Mirror to be displayed. To display all mirrors, select ALL.
Displaying the Pair Operation pane
133