HP XP Continuous Access Software - Manual (Page 134)

•
P-VOL/S-VOL: Type of volumes to be displayed.
To display all primary data volumes, select P-VOL. ◦
◦ To display all secondary data volumes, select S-VOL.
◦ To display all primary and secondary data volumes, select ALL.
•
CLPR: CLPR to be displayed. To display all CLPRs, select ALL.
•
Internal/External VOL: Specifies if internal or external volumes appear in the list.
To display all internal and external volumes, select ALL.
•
Status: Pair statuses. The volumes with the specified statues are displayed in the list.
•
Set: Applies settings in the Display Filter pane to the list.
•
Reset: Restores all options in the Display Filter pane to the default state. All lists display ALL.
All check boxes are selected.
Saving pair status information to a text file
Use the XP Continuous Access Journal snapshot function to save information about pair status in
a text file. This text file is called a snapshot file.
NOTE: You can use the snapshot function only while client file access is enabled. When client
file access is not enabled, the Snapshot button does not appear on the Pair Operation pane. For
more information about client file access settings, see the HP StorageWorks XP Command View
user guide for XP Disk Arrays or the HP StorageWorks XP Remote Web Console user guide for
XP12000/XP10000/SVS200.
NOTE: If the number of pairs exceed approximately 10,000, the snapshot function is too large
to save on a floppy disk. If this happens, save the snapshot file on a large-capacity disk.
The following is an example of a snapshot file.
<Pair Status at 03/04/2006 12:34:56>
Port Gr(Name) LUN Vol Status JNG Mr S/N(CNTL) Port Gr LUN Vol JNG Type CTG ErrLv Sync
CLPR
CL3-E 00(3E-G00 ) 000 00:00 PAIR 01 02 11111(04) CLG-R FF 1FF 3F:FF F6 P-VOL 09 Group
100 00:CLPR0
CL3-E 00(3E-G00 ) 008 00:08 SMPL 01:CLPR1
CL3-E 00(3E-G00 ) 009 00:09 PSUS 10 02 11111(04) CLG-R FF 1F6 3F:F6 ED P-VOL 12 LU 80
02:CLPR2
(1) (2) (3) (4) (5) (6) (7) (8) (9) (10) (11) (12) (13) (14) (15) (16) (17) (18)
Port in the local array 1
Group number and name of the host group or iSCSI target in the local
array (host group name is limited to a maximum of 16 characters) 2
LU number in the local array 3
CU and LDEV numbers in the local array 4
Pair status 5
Journal group number in the local array 6
Mirror ID 7
Remote array's serial number and controller ID 8
134 Performing XP Continuous Access Journal pair operations