Mpx100/100b log data, The mpx100/100b statistics, 74 port ip address conflict blink pattern – HP EVA Array iSCSI Connectivity Option User Manual

Page 175: 75 over-temperature blink pattern, Figure 74

Advertising
background image

Figure 74 Port IP address conflict blink pattern

Using the CLI or GUI, the IP address conflict blink pattern may be cleared using the Beacon OFF function.

Over-temperature blink pattern

An mpx100/100b over-temperature condition is indicated with a five-blink pattern followed by a

two-second pause. The five-blink error pattern indicates that the air temperature inside the mpx100/100b

has exceeded the failure temperature threshold at 70 °C (see

Figure 75

).

Figure 75 Over-temperature blink pattern

If the Heartbeat LED shows the over-temperature blink pattern, do the following:

1.

Inspect the chassis air vents. Are the intake and exhaust vents clear?
• If yes, continue with the next step
• If not, remove any debris from the fan intake and exhaust. If the condition remains, continue

with the next step.

2.

Consider the ambient air temperature near the mpx100/100b and clearance around the

mpx100/100b. Make necessary corrections.

3.

If the condition persists, power down the mpx100/100b. Contact your authorized maintenance

provider.

mpx100/100b log data

The mpx100/100b maintains a message log that can be displayed through the CLI or the mpx

Manager GUI. The message log is persistent up to 256 MB of log entries and is maintained across the

mpx100/100b power cycles and reboots.
The three log message categories are:

Informational

Error

Fatal

See

Log data

” on page 179 for more information.

The mpx100/100b statistics

Statistics are available from the mpx100/100b for the Fibre Channel and iSCSI ports, and can be

displayed through the CLI or the mpx Manager GUI. See

Show Stats command

” on page 168.

Troubleshooting LUN presentation from the EVA to the iSCSI

Initiator

This section describes basic troubleshooting when presenting a LUN from the EVA to the iSCSI Initiator.

In this process it is important to focus on the EVA port and the LUN because they must be presented

throughout the Fibre Channel and IP networks to the iSCSI Initiator.

EVA iSCSI connectivity user guide

175

Advertising