HP EVA Array iSCSI Connectivity Option - Manual (Page 88)

c. Under iSCSI software Adapter, choose the available software initiator.
d. Click the Properties link of the software adapter.
e. The iSCSI initator propeties dialog box is displayed. Click Configure.
f. The General properties dialog box displays (
Figure 39 ). Select the Enabled checkbox .
Figure 39 General properties dialog box
g. Click OK.
5. Set up Discovery Addressing for the software initiator:
a. Repeat
Step 4 to open the iSCSI initiator Properties dialog box.
b. Click the Dynamic Discovery tab.
c. Click Add to add a new iSCSI target. The Add Send Target Server dialog box is displayed.
d. Enter the mpx100’s/100b's iSCSI IP address (
Figure 40 ) and then click OK.
Figure 40 Add send targets server dialog box
6. See Creating an iSCSI initiator host via HP Command View EVA , page 130 for instructions to change
the host mode of the VMware initiator to VMware.
7. See iSCSI initiator setup for Windows (single-path) for instructions to set up LUNs using HP Command
View.
88 Setting up the iSCSI Initiator and storage