Restoring the mpx100/100b configuration, Restoring the mpx100 configuration – HP EVA Array iSCSI Connectivity Option User Manual
Page 214
4.
Enter the following command:
mpx100 (admin) #> fru save
FRU save completed.
Configuration File is HP_Storage-
Works_mpx100_FRU.bin.
Please use FTP to extract the file out from
the System.
mpx100 (admin) #>
NOTE:
The FRU save creates a bin file containing the router’s persistent data, configuration, and LUN
mappings. The file is stored in the routers /var/ftp directory. You must then FTP the tar file
from the router.
5.
Establish an FTP connection to the mpx100/100b management port and log in:
Username:
ftp
Password:
ftp
6.
Enter the following command to set the FTP transfer type to Binary:
ftp> bin
7.
Enter the following command to access the HP_StorageWorks_mpx100_FRU.bin file:
ftp> get HP_StorageWorks_mpx100_FRU.bin
Restoring the mpx100/100b configuration
There are two options for restoring configurations on the mpx100/100b:
•
Full Configuration Restore—Fully restores the router’s configuration (all configuration parameters
and LUN mappings)
•
Partial Restore (Mappings)—Restores only the LUN mappings
The restored configuration takes effect after the router is rebooted.
Restoring the configuration using the mpx100/100b GUI
To restore the configuration using the mpx100/100b GUI:
1.
Select File > Restore FRU.
The Restore FRU dialog box is displayed.
2.
Click Browse and select the appropriate file name to restore.
3.
Select Full Configuration Restore or Partial Restore (Mappings).
4.
Click Start.
The Security Check dialog box is displayed.
5.
Enter the password config, and then click OK.
6.
Reboot the system for the configuration to take effect.
Restoring the configuration using the mpx100/100b CLI
To restore the configuration using the mpx100/100b CLI:
1.
Establish an FTP connection to the mpx100/100b management port and log in:
Username:
ftp
Password:
ftp
2.
Enter the following command to set the FTP transfer type to binary:
ftp> bin
3.
Enter the following command to put the HP_StorageWorks_mpx100_FRU.bin file:
ftp> put HP_StorageWorks_mpx100_FRU.bin
4.
Log in to the mpx100/100b using a Telnet session to the management port or console port.
Username:
guest
214
Saving and restoring the mpx100/100b configuration